Controlled-products-systems-group 1503-080 Instrukcja Użytkownika Pobierz pdf (Strona 17)

Page 17

When operating the 1503 digital keypad entry device, each time a keypad button is pressed, a .2

second tone confirms the key press. This tone is not emitted during programming. When using the

four-digit entry codes or four-digit hold codes, the # key must be pressed first. When using the five-

digit entry codes, simply enter the five-digit code on the keypad.

3.1 Four-digit Entry Codes

To use a four-digit entry code, press the # key, and then enter the four-digit entry code. If a valid code

has been entered, the relay will activate for its programmed strike time and a tone will sound during

the relay activation period. If the relay is already activated by a HOLD code, entering a valid four-digit

entry code will cause the relay to deactivate.

3.2 Four-digit Hold Code

To use a four-digit hold code, press the # key, and then enter the four-digit hold code. If a valid code

has been entered, the relay will activate and a tone will sound for the relay strike time setting. After

the relay strike time runs out, the tone will stop but the relay will remain activated. To release a relay

that is being held, enter the four-digit hold code, or a valid four or five-digit entry code, or activate the

key switch input. A tone will sound for the programmed strike time, then the relay will release.

3.3 Five-digit Entry Codes

To use a five-digit entry code, enter the five-digit code on the keypad. If a valid code has been

entered, the relay will activate for its programmed strike time and a tone will sound during the relay

activation period. If the relay is already activated by a HOLD code, entering a valid five-digit entry

code will cause the relay to deactivate.

3.4 Request to Exit Input

A switch closure across terminals 4 and 5 will cause the relay to activate for the programmed strike

time and emit a tone during the activation period. If the relay is already activated by a HOLD code, a

switch closure across terminals 4 and 5 will cause the relay to deactivate.

SECTION 3 – OPERATING INSTRUCTIONS

DIGITS ENTERED

1 2 3 4 5

Master Code

4-Digit Code 1

4-Digit Code 2

4-Digit Hold Code 1

4-Digit Hold Code 2

5-Digit Code 1

5-Digit Code 2

1 2 ... 12 13 14 15 16 17

Brak uwag

Controlled-products-systems-group 1503-080 Instrukcja Użytkownika Strona 17