Controlled-products-systems-group 8550C-7 Instrukcja Użytkownika Pobierz pdf (Strona 17)

Introduction

Be sure power is NOT connected to the garage

door opener BEFORE installing the safety

reversing sensor.

To preventSERIOUS INJURY or DEATHfrom

closing garage door:

• Correctlyconnect and align the safety

reversing sensor.Thisrequired safety

device MUST NOT be disabled.

• Install the safetyreversing sensor so beam

is NO HIGHER than 6" (15 cm) above

garage floor.

Install the Protector System

IMPORTANTINFORMATIONABOUTTHESAFETYREVERSINGSENSORS

The safety reversingsensors must be connectedandaligned correctly before the garage door opener willmove in the down direction.

The sending sensor (with an amber LED) transmits an invisible lightbeam to the receiving sensor (with a green LED).Ifan obstruction breaks the light

beam while the door is closing, the door will stop and reverse to the full open position,and the garage door opener lightswill flash 10 times.

NOTE: For energy efficiency the garage door opener will enter sleep mode when the door is fully closed. The sleep mode shuts the garage door

opener down until activated. The sleep mode is sequenced with the garage door opener light bulb; as the light bulb turns off the sensor LEDs will turn

off and whenever the garage door opener lights turn on the sensor LEDs will light. The garage door opener will not go into the sleep mode until the

garage door opener has completed 5 cycles upon power up.

When installingthe safety reversingsensors check the following:

• Sensors are installed inside the garage, one on either side of the door.

• Sensors are facing each other with the lenses aligned and the receiving sensor lens does not receive directsunlight.

• Sensors are no more than 6 inches (15 cm) above the floor and the lightbeam isunobstructed.

Invisible Light Beam

Protection Area

Safety Reversing Sensor

6" (15 cm) max. above floor

Safety Reversing Sensor

6" (15 cm) max. above floor

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 81 82

Komentarze do niniejszej Instrukcji

Brak uwag

Controlled-products-systems-group 8550C-7 Instrukcja Użytkownika Strona 17

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Czujniki Controlled-products-systems-group 8550C-7